Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual page 1907

Learned Port Security Commands
•
The conversion of dynamic MAC addresses to static ones does not apply to LPS ports.
Note. The LPS source learning time window has a higher priority over the maximum number of MAC
addresses allowed. For example, if the maximum number of MAC addresses allowed is set at 30 and the
learning interval expires when the port has only learned 15, then the port does not learn anymore MAC
addresses.
Examples
-> port-security learning-window 25
-> port-security learning-window 60
-> port-security learning-window 2 convert-to-static enable
-> port-security learning-window 2 convert-to-static disable
-> no port-security learning-window 25
Release History
Release 7.1.1; command introduced.
Related Commands
port-security
port-security port mac-range
port-security port maximum
port-security port violation
MIB Objects
learnedPortSecurityGlobalGroup
lpsLearningWindowTime
lpsLearningWindowTimeWithStaticConversion
lpsConvertToStatic
OmniSwitch CLI Reference Guide
Enables or disables Learned Port Security (LPS) on the switch port(s).
Configures a list of authorized MAC addresses by defining a range of
addresses allowed on the port.
Specifies the maximum number of source MAC addresses that an LPS
port(s) is allowed to learn.
Selects the method for handling traffic that does not comply with LPS
restrictions for the specified port.
March 2011
port-security learning-window
page 30-5