Show Policy Port Group - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

show policy port group

show policy port group
Displays information about pending and applied policy port groups.
show [applied] policy port group [group_name]
Syntax Definitions
applied
group_name
Defaults
N/A
Platforms Supported
OmniSwitch 10K
Usage Guidelines
Information for all policy port groups displays unless group_name is specified.
Examples
-> show policy port group
Group Name
State
Entries
output definitions
Group Name
State
Entries
Release History
Release 7.1.1; command was introduced.
page 26-160
Indicates that only policy port groups that have been applied should be
displayed.
The name of the policy port group for which you want to display infor-
mation; or a wildcard sequence of characters for displaying information
about port groups with similar names. Use an asterisk (*) to indicate a
wildcard character.
: pg1
= new,
= 1/2,
1/3,
1/4,
3/11
The name of the port group, configured through the policy port group
command or built-in port groups automatically set up by the switch
(Slot01, Slot02, Slot03, etc.).
This field appears if the group was created or modified but not yet
applied to the QoS configuration. When the qos apply command is
issued, this field no longer displays.
The slot/port combinations associated with the port group.
QoS Policy Commands
OmniSwitch CLI Reference Guide March 2011