Policy Action Maximum Bandwidth - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

QoS Policy Commands

policy action maximum bandwidth

Configures a maximum bandwidth value for a policy action.
policy action action_name maximum bandwidth bps[k | m | g | t]
policy action action_name no maximum bandwidth
Syntax Definitions
action_name
bps[k | m | g | t]
Defaults
parameter
k | m | g | t
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
Use the no form of the command to remove a maximum bandwidth value from an action.
•
If the maximum bandwidth value is specified as an integer, without an abbreviated unit designation,
the value is applied in kbps by default. For example, if the number 10 is specified, 10K is the maxi-
mum bandwidth value used. However, if 10G is specified, the maximum bandwidth value applied is 10
gbps.
•
Use the shared policy action to enabling sharing of bandwidth across policy rules that specify the same
maximum bandwidth action.
Examples
-> policy action action3 maximum bandwidth 10000
-> policy action action4 maximum bandwidth 10k shared
-> policy action action5 maximum bandwidth 10k shared
-> policy action action4 no maximum bandwidth
Release History
Release 7.1.1; command was introduced.
OmniSwitch CLI Reference Guide
The name of the action.
The maximum amount of bandwidth, in bits-per-second, for all traffic
that ingresses on the port. The value may be entered as an integer (for
example, 10) or with abbreviated units (for example, 10k, 5m, 1g, 1t).
default
k
March 2011
policy action maximum bandwidth
page 26-125