Policy Action Permanent Gateway-Ip - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

QoS Policy Commands

policy action permanent gateway-ip

Used for Policy Based Routing (PBR). Routed flows to which this action is applied will be directed to the
IP address specified in the action regardless of whether or not a route already exists in the switch routing
table.
policy action action_name permanent gateway-ip ip_address
policy action action_name no permanent gateway-ip
Syntax Definitions
action_name
ip_address
Defaults
N/A
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
Use the no form of the command to remove a gateway IP address from a policy action.
•
If the gateway goes down, the traffic to be routed over the gateway will be dropped.
Examples
-> policy action pbr2 permanent gateway-ip 10.10.2.1
-> policy action pbr2 no permanent gateway-ip
Release History
Release 7.1.1; command was introduced.
Related Commands
qos apply
policy action
show policy action
OmniSwitch CLI Reference Guide
The name of the action.
The destination IP address to which packets will be routed.
Applies configured QoS and policy settings to the current configuration.
Creates a policy action.
Displays information about policy actions.
March 2011
policy action permanent gateway-ip
page 26-141