show log swlog
show log swlog
Displays stored switch logging information.
show log swlog
show log swlog [session session_id] [timestamp start_time [end_time]] [appid appid] [level level]
Syntax Definitions
session_id
start_time
end_time
appid
Supported Application IDs and their Numeric Equivalents
802.1q - 7
aaa - 20
amap - 18
bridge - 10
chassis - 64
cli - 67
config - 66
dbggw - 89
diag - 0
distrib - 84
drc - 74
eipc - 26
epilogue - 85
ftp - 82
gmap - 19
health - 76
idle - 255
interface - 6
page 35-10
Identification number of the session for which switch logging
information is displayed.
Specify the starting time for the switch logging information to be
displayed. Use the format mm/dd/yyyy hh:mm where mm represents the
month, dd is the day, yyyy is the year, hh is the hour, and mm is the
minutes. Use four digits to specify the year.
Specify the ending time for the switch logging information to be
displayed. Use the format mm/dd/yyyy hh:mm where mm represents the
month, dd is the day, yyyy is the year, hh is the hour, mm is the minutes.
Use four digits to specify the year.
A digit that represents the application ID for the switch logging
information to be displayed. Values are listed in the following table.
ip - 15
ipc-diag - 1
ip-helper - 22
ipc-link - 4
ipc-mon - 21
ipms - 17
ipx - 16
ldap - 86
linkagg - 12
mipgw - 70
module - 24
nan-driver - 78
ni-supervision - 5
nosnmp - 87
pmm - 23
policy - 73
port-mgr - 64
psm - 81
Switch Logging Commands
qdispatcher - 3
qdriver - 2
qos - 13
rmon - 79
rsvp - 14
session - 71
slb - 25
smni - 83
snmp - 68
ssl - 88
stp - 11
system - 75
telnet - 80
trap - 72
vlan - 8
vrrp - 77
web - 69
OmniSwitch CLI Reference Guide
March 2011