Policy Condition Inner Source-Vlan - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

QoS Policy Commands

policy condition inner source-vlan

Configures an inner source VLAN ID as a policy condition. This condition applies to double-tagged
VLAN Stacking traffic and is used to classify such traffic based on the inner VLAN ID tag, also known as
the customer VLAN ID.
policy condition condition_name inner source-vlan vlan_id
policy condition condition_name no inner source-vlan
Syntax Definitions
condition_name
vlan_id
Defaults
N/A
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
Use the no form of the command to remove an inner source VLAN from a policy condition; however,
at least one classification parameter must be associated with a condition.
•
Policies that use the inner source VLAN condition are referred to as QoS VLAN Stacking policies.
These are separate policies from those configured through the VLAN Stacking Service application.
Examples
-> policy condition cond5 inner source-vlan 3
-> policy condition cond5 no inner source-vlan
Release History
Release 7.1.1; command was introduced.
Related Commands
qos apply
policy condition
show policy condition
OmniSwitch CLI Reference Guide
The name of the condition. May be an existing condition name or a new
condition.
The inner source VLAN ID (customer VLAN ID) to match on double-
tagged packets.
Applies configured QoS and policy settings to the current configuration.
Creates a policy condition.
Shows information about policy conditions configured on the switch.
March 2011
policy condition inner source-vlan
page 26-99