Intel ITANIUM ARCHITECTURE - SOFTWARE DEVELOPERS MANUAL VOLUME 1 REV 2.3 Manual page 1421

Hide thumbs Also See for ITANIUM ARCHITECTURE - SOFTWARE DEVELOPERS MANUAL VOLUME 1 REV 2.3:
Table of Contents

Advertisement

FCOS—Cosine (Continued)
FPU Flags Affected
C1
C2
C0, C3
Additional Itanium System Environment Exceptions
Itanium Reg Faults Disabled FP Register Fault if PSR.dfl is 1, NaT Register Consumption
Floating-point Exceptions
#IS
#IA
#D
#U
#P
Protected Mode Exceptions
#NM
Real Address Mode Exceptions
#NM
Virtual 8086 Mode Exceptions
#NM
Volume 4: Base IA-32 Instruction Reference
Set to 0 if stack underflow occurred.
Indicates rounding direction if the inexact-result exception (#P) is
generated: 0 = not roundup; 1 = roundup.
Undefined if C2 is 1.
Set to 1 if source operand is outside the range 2
otherwise, cleared to 0.
Undefined.
Abort.
Stack underflow occurred.
Source operand is an SNaN value, , or unsupported format.
Result is a denormal value.
Result is too small for destination format.
Value cannot be represented exactly in destination format.
EM or TS in CR0 is set.
EM or TS in CR0 is set.
EM or TS in CR0 is set.
63
63
to +2
;
4:119

Advertisement

Table of Contents
loading

This manual is also suitable for:

Itanium architecture 2.3

Table of Contents