Intel ITANIUM ARCHITECTURE - SOFTWARE DEVELOPERS MANUAL VOLUME 1 REV 2.3 Manual page 1839

MOVSS: Move Scalar Single-FP (Continued)
xmm2[127-96] = xmm2[127-96];
}
}
The linear address corresponds to the address of the least-significant byte of the
Description:
referenced memory data. When a memory address is indicated, the 4 bytes of data at
memory location m32 are loaded or stored. When the load form of this operation is
used, the 32-bits from memory are copied into the lower 32 bits of the 128-bit register
xmm, the 96 most significant bits being cleared.
None
FP Exceptions:
None
Numeric Exceptions:
Protected Mode Exceptions:
#GP(0) for an illegal memory operand effective address in the CS, DS, ES, FS or GS
segments; #SS(0) for an illegal address in the SS segment; #PF (fault-code) for a page
fault; #UD if CR0.EM = 1; #NM if TS bit in CR0 is set; #AC for unaligned memory
reference. To enable #AC exceptions, three conditions must be true(CR0.AM is set;
EFLAGS.AC is set; current CPL is 3); #UD if CRCR4.OSFXSR(bit 9) = 0; #UD if
CPUID.XMM(EDX bit 25) = 0.
Real Address Mode Exceptions:
Interrupt 13 if any part of the operand would lie outside of the effective address space
from 0 to 0FFFFH; #UD if CR0.EM = 1; #NM if TS bit in CR0 is set; #UD if
CRCR4.OSFXSR(bit 9) = 0; #UD if CPUID.XMM(EDX bit 25) = 0.
Virtual 8086 Mode Exceptions:
Same exceptions as in Real Address Mode; #AC for unaligned memory reference if the
current privilege level is 3; #PF (fault-code) for a page fault.
Additional Itanium System Environment Exceptions
Itanium Reg Faults
Itanium Mem Faults VHPT Data Fault, Data TLB Fault, Alternate Data TLB Fault, Data
Volume 4: IA-32 SSE Instruction Reference
Disabled FP Register Fault if PSR.dfl is 1, NaT Register
Consumption Fault
Page Not Present Fault, Data NaT Page Consumption Abort, Data
Key Miss Fault, Data Key Permission Fault, Data Access Rights
Fault, Data Access Bit Fault, Data Dirty Bit Fault
4:537