Intel ITANIUM ARCHITECTURE - SOFTWARE DEVELOPERS MANUAL VOLUME 1 REV 2.3 Manual page 1315

2.2.1.1 Opcode Column
The "Opcode" column gives the complete object code produced for each form of the
instruction. When possible, the codes are given as hexadecimal bytes, in the same
order in which they appear in memory. Definitions of entries other than hexadecimal
bytes are as follows:
• /digit – A digit between 0 and 7 indicates that the ModR/M byte of the instruction
uses only the r/m (register or memory) operand. The reg field contains the digit
that provides an extension to the instruction's opcode.
• /r – Indicates that the ModR/M byte of the instruction contains both a register
operand and an r/m operand.
• cb, cw, cd, cp – A 1-byte (cb), 2-byte (cw), 4-byte (cd), or 6-byte (cp) value
following the opcode that is used to specify a code offset and possibly a new value
for the code segment register.
• ib, iw, id – A 1-byte (ib), 2-byte (iw), or 4-byte (id) immediate operand to the
instruction that follows the opcode, ModR/M bytes or scale-indexing bytes. The
opcode determines if the operand is a signed value. All words and doublewords are
given with the low-order byte first.
• +rb, +rw, +rd – A register code, from 0 through 7, added to the hexadecimal byte
given at the left of the plus sign to form a single opcode byte. The register codes
are given in
• +i – A number used in floating-point instructions when one of the operands is ST(i)
from the FPU register stack. The number i (which can range from 0 to 7) is added to
the hexadecimal byte given at the left of the plus sign to form a single opcode byte.
Table 2-1.
AL
CL
DL
BL
AH
CH
DH
BH
2.2.1.2 Instruction Column
The "Instruction" column gives the syntax of the instruction statement as it would
appear in an ASM386 program. The following is a list of the symbols used to represent
operands in the instruction statements:
• rel8 – A relative address in the range from 128 bytes before the end of the
instruction to 127 bytes after the end of the instruction.
• rel16 and rel32 – A relative address within the same code segment as the
instruction assembled. The rel16 symbol applies to instructions with an
operand-size attribute of 16 bits; the rel32 symbol applies to instructions with an
operand-size attribute of 32 bits.
Volume 4: Base IA-32 Instruction Reference
Table 2-1.
Register Encodings Associated with the +rb, +rw, and +rd
Nomenclature
rb
= 0 AX
= 1 CX
= 2 DX
= 3 BX
rb
= 4 SP
= 5 BP
= 6 SI
= 7 DI
rw
= 0 EAX
= 1 ECX
= 2 EDX
= 3 EBX
rw
= 4 ESP
= 5 EBP
= 6 ESI
= 7 EDI
rd
= 0
= 1
= 2
= 3
rd
= 4
= 5
= 6
= 7
4:13