Activating The End-Point Module (Automatic Wireless Setup) - Thermo Scientific Smart-Vue Installation Manual

Installation procedure
Activating the end-point
module (automatic
wireless setup)
Smart-Vue Dry Contact Module Installation Guide
10
The Smart-Vue dry contact monitor is a standalone device that runs on
battery power. To activate your Smart-Vue end-point module and add it
automatically to your wireless monitoring network, do the following:
1. Insert the provided battery, if not already installed, making sure to
respect the polarity (see image printed inside battery slot). We
recommend that you use a manual screwdriver, being careful not to
over-tighten the screws.
Figure 4. Remove the back cover and insert backup battery
2. To begin collecting data on the state of your contact right away,
make sure that Smart-Vue Client is running with a properly
configured receiver, and then initiate the wireless configuration
sequence by pressing the button on the front of the end-point
module for 3 seconds (until "Searching" displays on the screen).
This installation method is designed for networks with up to about 15
end-point modules. For larger sites, please see the Thermo Scientific
Smart-Vue Software User Manual for setup instructions or check with an
experienced technician.
Thermo Fisher Scientific