Inter-Tel AXXESS Manual page 1084

Programming
® ®
INTER-TEL AXXESS
•
•
•
Search Algorithm
4.302 The trunk group can be programmed for linear or distributed trunk searching, as
described below. Select the Search Algorithm value and then scroll to the desired setting. Then
press
•
•
Audio for Calls Camped onto this Device
4.303 The Audio for Calls Camped onto this Device field defines the audio that a caller hears
when camped-on to this node trunk or IP connection group. To program this field, use the
drop-down list to select the type of audio and press
tone, Ringback, or Board. If you select
field. The default is Board, and the default extended value is 01:08 Central Processor.
Music-On-Hold
4.304 The music-on-hold option that will be heard by outside callers on the trunks in the trunk
group can be set for tick tones, ringback, board (music), silence, or to use the next device's
audio source. Select the current Music-On-Hold value and scroll to the desired setting (Silence,
Tick Tone, Ringback, Board, or Use Next Device's Audio Source). To use the audio pro-
grammed at individual stations, select
select the Extended Value and scroll to the desired board where the music source is connected.
When you have made your selection, press
change.
Page 6-234
MANUAL VERSION 11.0 – May 2008
Absorbed Patterns: If the Absorbed Digits and PBX Line flags are enabled, use this
field to enter the absorbed digit patterns. There can be up to 50 patterns with up to 48
digits each. The only characters allowed in the pattern are digits (0-9), pound [hash]
sign (#), parentheses ( ), brackets ([ ]), greater than (>) and less than (<) symbols, and
the wildcards. (See page 5-111
to view the current list of patterns, if any. To add a pattern, do the following:
Patterns
Right-click anywhere in the right side of the screen and select
a.
. A new, blank pattern appears on the list.
Patterns List
Select the pattern to display the text box and enter the desired pattern. Then press
b.
or click outside the field to save the change.
ENTER
Repeat these steps if you need additional patterns.
c.
PBX Line: Trunk groups can be programmed to absorb a digit string (defined above)
for PBX installations. To enable this flag, select the current Value and then select the
check box to place a check in it. Then press
change. (To remove the check and disable the flag, select the check box again.)
Absorbed Digit String: If the PBX Line flag, described above, is enabled, use this field
to enter the absorbed digit string. Click on the current Value and enter the new digit
string, up to 32 digits. Then press
only characters allowed in the string are digits (0-9), pound [hash] sign (#), parentheses
( ), brackets ([ ]), greater than (>) and less than (<) symbols, and the wildcards. (See
page 5-111 for wildcard information.).
or click outside the field to save your change.
ENTER
Linear Trunk Group: Requests for an outgoing trunk are always processed beginning
with the highest numbered trunk on the list and moving down the list until an available
trunk is found.
Distributed Trunk Group: The first request will be processed beginning with the high-
est numbered trunk on the list. The next request will begin with the second trunk, and
each subsequent request will begin one trunk lower on the list. When the end of the list
is reached, requests begin again with the highest numbered trunk on the list.
for wildcard information.) Double-click on
or select another field to save the
ENTER
or select another field to save the change. The
ENTER
. Your options are Silence, Tick-
ENTER
, specify the music source in the Extended Value
Board
Use Next Device's Audio Source
or click outside the field to save your
ENTER
Absorbed
Add To Absorbed
. If you select ,
Board
CO Trunk Groups