Inter-Tel AXXESS Manual page 1002

Hide thumbs Also See for AXXESS:

Table of Contents

3.148 To program the circuits for MGCP endpoints:

3.149 To program the circuits for SIP trunks:

Inter-Tel Axxess/5000 Quintum SIP Gateway Installation Manual (document part no. 835.3123)

or the Inter-Tel Axxess/5000 AudioCodes MP-114 SIP Gateway Installation Manual (document

part no. 835.3202).

MANUAL VERSION 11.0 – May 2008

Under System\Cabinets\Internet Protocol Resource Card, expand the Devices folder.

Highlight the circuits to program, right-click, and select

MGCP Endpoint

If there is not an MGCP gateway currently programmed on the card, an error

message appears. Program at least one circuit to be an MGCP Gateway and Endpoint

before attempting to program additional endpoints.

Select the starting extension for the endpoints.

Click an endpoint in the list and enter an endpoint name, up to 20 characters. Inter-Tel

recommends that you use a naming convention to avoid resolution problems. By

default, the endpoints are named ACgwX, where X is a number (0-3) that identifies the

port. For example, the endpoint in the first port is ACgw0; the endpoint in the second

port is ACgw1; etc. (Hostnames are case-sensitive.)

The endpoint names entered in DB Programming must match those pro-

grammed in the gateway configuration. For details, refer to the Inter-Tel Axxess/5000

Quintum SIP Gateway Installation Manual (document part no. 835.3123) or the Inter-Tel

Axxess/5000 AudioCodes MP-114 SIP Gateway Installation Manual (document part no.

to accept the name.

Select the extension for the MGCP gateway that the endpoints will use and click

Under System\Cabinets\Internet Protocol Resource Card, expand the Devices folder.

Highlight the circuits to program, right-click, and select

Select the starting extension for the SIP trunk and click

For complete information about installing and configuring a SIP gateway, refer to the

Internet Protocol Resources Card

Batch Change Type

Chapters

Table of Contents