Inter-Tel AXXESS Manual page 1237

NOTE:
pairs. For example, if you add or delete a primary cascade level, a corresponding alter-
nate cascade level is not automatically added or deleted.
When you want to program the cascades settings, double-click on the cascade you want
to program to view the following options:
—
—
—
—
—
Mailbox Programming
®
INTER-TEL AXXESS
As of version 7.0, primary and alternate cascade levels are not equipped in
Timers and Limits: Double-click on
ing. If necessary, enter a new Value and then press
field to save your change.
Number Of Call Attempts: Determines how many times the Voice Processor
will attempt to complete a call to this cascade level before moving to the
next level. The range is 1-1000 call attempts and the default value is 1.
Number Called Busy Timer: Defines the amount of time the Voice Processor
will wait between outgoing call attempts whenever a busy signal is encoun-
tered during a remote message notification attempt to a personal number or
pager. The range is 0-1440 minutes and the default value is 5.
Personal Number No Answer Timer: Defines the amount of time the Voice
Processor will wait between outgoing call attempts whenever a message noti-
fication attempt to a personal number is unanswered. The range is 0-1440
minutes and the default value is 30.
Pager Notification Retry Timer: Reflects the amount of time the Voice Pro-
cessor will wait between outgoing call attempts when the notification num-
ber is a pager. The range is 0-1440 minutes and the default value is 20.
Enable Notification: Each cascade can be enabled or disabled individually. To
change the setting, click on the check box to place a mark in it and set the flag to
. (Or click on an existing mark to disable it and change the flag to
Yes
press or click on another field to save your change.
ENTER
Call Progress Detection: This determines if the Voice Processor will perform call
progress detection after dialing the notification number and outgoing termination
fields on outside calls. If it is enabled, the system will analyze call progress tones
after sending the telephone number. If it is disabled, the system will assume the
call has been answered, without analyzing tones. This should only be disabled in
cases where call progress tones are not used (lighting a message lamp) or when
the tones used by the destination cannot be recognized by the system (some pager
destinations). To change the setting, click on the check box to remove the mark in
it and set the flag to . (Or click on it again to enable it and change the flag to
No
.) Then press or click on another field to save your change.
Yes ENTER
Notification Type: The message notification number can be identified as a per-
sonal number (a person will answer the call) or a pager. (This defaults to "personal
number.") Select the drop-down list box and scroll to the desired setting. Then
press or click on another field to save your change.
ENTER
Notification Destination Type: This indicates whether the notification call is
going to an intercom (IC) or outside (CO) destination. This can also be pro-
grammed by the mailbox Subscriber. Select the drop-down list box and scroll to
the desired setting. Then press
change.
®
MANUAL VERSION 11.0 – May 2008
to program the follow-
Timers and Limits
ENTER
or click on another field to save your
ENTER
Programming
or click on another
.) Then
No
Page 6-387
6