Inter-Tel AXXESS Manual page 1529

NOTE:
connection port with the settings at 9600 bps, 8 bits, 1 stop bit, and no parity.
Start a new DB Studio session using a network connection that connects to the IP
20.
address (or hostname) programmed in
Run the DB Test Utility on the backed up database with the
21.
enabled.
Make sure the Voice Processing Unit is attached and restore the converted database.
22.
If implementing IPRC networking, add the appropriate IPRCs.
23.
If necessary, upgrade any existing IPRCs, T1Cs, IP endpoints, etc.
24.
Program the system database to incorporate the desired v9.0 or later features. If you are
25.
expanding the system network to support more than 64 nodes, perform a 99 nodes vali-
dation test described on
Test the system and voice mail to make sure everything is functioning properly.
26.
If implementing IPRC networking, remove any unnecessary T1Cs and/or IP Network-
27.
ing Modules.
Install the CT Gateway upgrade software v4.201 or later. Do not uninstall the previous
28.
version; otherwise, you will have to reconfigure all CT Gateway settings. After you
have installed the new version, start the CT Gateway and make sure all of the previ-
ously configured switch connections are properly communicating with the Gateway. To
verify the connections, select
Because some applications, such as Contact Center Suite, (previously knows as Call
29.
Center Suite) require a database that does not contain duplicate extensions or trunks,
use the "Find Duplicate Data" feature to identify redundant extensions. To find dupli-
cate data, select View - Database -
Use the
30.
connections that are required. In some cases, you can use the
option, but it is often just as easy to use the manual configuration option and click
to add each new connection individually.
Upgrade Attendant Consoles to version 3.004 or later and start them.
31.
Start any other CT applications that connect to the CT Gateway.
32.
2.3
For details about specific steps, see the installation manual for the appropriate product
(e.g., Axxess system, CT Gateway, Attendant Console, etc.).
Version 11.0 Upgrade Instructions
®
INTER-TEL AXXESS
A better way that does not require a reset would be to use a terminal serial
page E-8 after each of the new nodes is added to each site.
Switch Connections
By Node
option under the File menu to add any new switch
New Switch Connection
Appendix E — Upgrading to v11.0
®
MANUAL VERSION 11.0 – May 2008
step 19.
Test/Repair All
from the View menu.
and then click
Find Duplicate Data
Auto Configuration
option
.
Find
Page E-7