Emergency; Home Area Codes (U.s. Only) - Inter-Tel AXXESS Manual

Programming
® ®
INTER-TEL AXXESS
D. EMERGENCY
9.24 The System\Numbering Plan\Emergency programming area is used for programming
the emergency number(s) that will be used when the Emergency Call feature code is entered by
a station user.
9.25 Emergency calls, by default, use the first local trunk group and will not be sent through
other nodes using node trunk groups. However, when ARS is used to place an emergency call,
Route Group 1 is used even if it contains nodes. This means that the network can access a
trunk on a node other than the user's node if the user accesses ARS and dials the emergency
number. Inter-Tel highly recommends that local trunks be installed and used for emergency
number trunk access and that nodes are not used in Route Group 1. When a user places an
emergency call, every administrator in the network receives an emergency alarm.
9.26 The Emergency Numbers folder stores up to ten emergency numbers that are dialed
when the Emergency Call feature is used. For details about the emergency call feature, see
page
9.27 To program or change emergency numbers, double-click on
Then select the current value (or blank field) of the number you want to program. Enter the
desired number, up to 48 digits, in the text box. Then press
save the entry. Only the first emergency number has a default value 911 [999].
It shall be the responsibility of the entity or person(s) completing installation and mainte-
nance of hardware or software described herein to research, comply with and be responsi-
ble for the specific governmental rules and regulations regarding Emergency Outgoing
Access 911 [999] of the geographic location in which such functions are performed.
E. HOME AREA CODES (U.S. ONLY)
9.28 The database requires a "home" area code for identifying local calls. It also allows up to
15 additional home area codes. The system refers to these area codes for toll restriction and
call cost. The first area code programmed behaves differently from the next 15 home area
codes. For the first area code programmed, the area code digits are stripped from the dialed
outgoing number. To program the home area code(s) for the system site, select the current Dig-
its and enter the new area code in the text box. Then press
save the change.
Page 6-286
MANUAL VERSION 11.0 – May 2008
Table 6-29:
Base Extension Numbers
Device
Page Zone
Record-A-Call
Remote Node
Single-Line
STAR
Trunk
Voice Mail
5-112.
Base Extension
9600
2500
97001
1000
2500
94000
2500
ENTER
NOTICE
or click outside the field to
ENTER
.
Emergency Numbers
or select another field to

Emergency