Inter-Tel AXXESS Manual page 1364

Troubleshooting
® ®
INTER-TEL AXXESS
Quick Network Setup
Warning! A non-default Call Processing database will overwrite these
settings!
Address-assignment protocol selection:
Would you like to use BOOTP (Y/N)? n
Would you like to use DHCP (Y/N)? n
No address-assignment protocol selected; please enter static
information.
IP Address:
Subnet Mask:
Default IP Gateway Address:
Hostname:
IP Address:
Subnet Mask:
Default IP Gateway Address:
Hostname:
Would you like to continue with these values (Y/N)? y
To activate all changes, a RESET must occur.
Would you like to reset the card (Y/N)? y
Resetting ...
12.
13.
8.7
86.
Page 7-84
MANUAL VERSION 11.0 – May 2008
Select Programming Menu, then
c.
illustration below. For the IP address and subnet mask, enter the values required
for your network.
10.16.240.32 ? 192.168.200.201 (or your values)
255.255.200.0 ? 255.255.255.0
TEST_CPC - Change (Y/N) ? n (leave alone)
192.168.200.201
255.255.255.0
TEST_CPC
NOTE:
Some of the fields should be left alone, as indicated in the illustration. These
settings are temporary and must be duplicated in DB Programming.
Attempt to log on again. If you cannot log in using these network settings, repeat step 9
using the following default settings:
•
IP Address: 192.168.200.201
•
Subnet Mask: 255.255.255.0
•
Default IP Gateway Address: 192.168.0.1
Attempt to log on again.
If you still cannot log on, restore the CPC to the default settings as described in
. Enter the values as shown in the
Quick Setup
192.168.20.21 ? (leave alone)
192.168.20.21
Troubleshooting the IP Port
page 7-