Configuration Tab - Inter-Tel AXXESS Manual

Hide thumbs Also See for AXXESS:

Table of Contents

A. CONFIGURATION TAB

22.4 With the Configuration tab, you can program the device limit and specify the point-of-

reference for the CP Server clock.

Database device limit: Select the database device limit. Your options are dual-chassis

(256), quad-chassis (512), CP Server (1024), or ATM. This field is available when you

first install the software (or when the static_memory.mmf file has been deleted). If

you select the 1024 database option, the maximum number of devices the database can

support is increased to 1024. However, because the chassis cannot support 1024

devices, the total number of devices is limited by the hardware capacities. By default,

this is set to 512.

1024 database configured, you cannot revert to a 512.

Use CPU Real-Time Clock: Select this option to have the CP Server set and read the

date and time from the remote chassis rather than from the PC Clock. If disabled

(default), the CP Server reads the date and time from its PC Clock. If you select this

option, make sure the battery strap is connected on the first PCMA board (ATM Sys-

If the PC is currently synchronizing its time with an external clock (e.g., using Windows Time

Service or some other utility), do not enable this option. Using a synchronization utility with

this option enabled may result in unpredictable clock information. For best results, have the

PC synchronize the time and disable the Use CPU Real-Time Clock option for the CP

Configuration Tab

You cannot revert to a smaller database. For example, if you currently have a

Appendix C — CP Server

MANUAL VERSION 11.0 – May 2008

Table of Contents