Remote Programming Feature - Inter-Tel AXXESS Manual

System Features
® ®
INTER-TEL AXXESS

47. REMOTE PROGRAMMING FEATURE

47.1 The Remote Programming feature (359) allows a user to forward a station's calls,
change the station's DND status, and program the station's password from another station or
through DISA. Each station has a password to limit access to this feature. (See
information about DISA.)
47.2 In a network, Remote Programming can be performed on one node for any phone that is
programmed as an off-node device on that node (see
ming information). You must go through DISA for remote programming of any phones that are
not programmed as off-node devices. The features that can be programmed remotely are as fol-
lows:
•
•
•
•
•
•
•
A. STATION PASSWORD
47.3 The station password is used only for the Remote Programming feature.
NOTE:
gramming should have a password. To make the passwords difficult to guess, they should not
match the extension number or consist of one digit repeated several times.
47.4 The station password can be up to eight digits in length. The default password is the
extension number of the station. The password can be changed by entering the Program Station
Password feature code at the station or when using the Remote Programming feature. It can
also be programmed through Individual Station programming.
47.5 If the password is changed from a station, the user will be prompted for the old pass-
word, then the new password, and will be asked to verify the new password. If it is pro-
grammed through Remote Programming, the user will already have entered a correct
password. So, the user is only prompted for the new password and will be asked to verify the
password.
47.6 If the verified password and new password not match, the old password will be retained
and the programming session will be canceled.
47.7 To change the station password from your station:
1.
2.
Page 5-262
MANUAL VERSION 11.0 – May 2008
Call Forward All Calls (feature code 355)
Call Forward If No Answer (356)
Call Forward If Busy (357)
Call Forward If No Answer/Busy (358)
Do-Not-Disturb (370)
Do-Not-Disturb Cancel (371)
Program Station Password (392)
To prevent unauthorized use of the call forward feature, all stations using Remote Pro-
Enter the Program Station Password feature code (392). You hear a confirmation tone.
If you have a display, it shows ENTER PASSWORD.
Enter your current password, followed by #. (At default, it is your extension number.) If
you have a display, it shows NEW PASSWORD.
NOTE:
If you enter an incorrect password, the display will show INVALID PASS-
WORD, and your station will return to the idle state.
page 6-198 for off-node device program-
Remote Programming Feature
page 5-118 for