Table 7-22 Iprc Diagnostics Displays; Iprc Diagnostic Displays - Inter-Tel AXXESS Manual

Enter A (not case-sensitive) at the Enter selection prompt. The Programming Menu
4.
appears, as shown below.
Enter D (not case-sensitive) at the Enter selection prompt to access the diagnostic infor-
5.
mation.
Enter the letter associated with the desired display. See the following section for a list
6.
of available screens.
D. IPRC DIAGNOSTIC DISPLAYS
7.11 The following table describes the available displays and the information associated with
each screen. The display name for both the serial and Web interface is also indicated where
applicable.
NOTE:
Table 7-22.
Serial
Display Name
Network
Information
Version
Information
NICS Statistics
Thread
Registry
Timer Alarm
Statistics

IPRC Diagnostic Displays

INTER-TEL
"N/A" indicates that the display is not available when using a Web interface.
IPRC Diagnostics Displays
Web
Display Name
Network Information about the status of the network, the card's
Ethernet address, subnet mask, gateway IP address, and
WINS information.
Firmware Information about the version of the boot code and the
Version application code.
N/A Information about the Ethernet driver. This display may
point out problems with the Ethernet driver or assist in
solving bandwidth- and Ethernet-related problems.
N/A Information about the threads in the system, showing the
name, priorities, and state of each thread.
N/A Information about the timer alarms that may be running
on the IPRC. Currently, the IPRC uses timer alarms for
LED flashing and setting the audio-receive timers.
® ®
AXXESS MANUAL VERSION 11.0 – May 2008
Contains
Troubleshooting
Page 7-75
7