Inter-Tel AXXESS Manual page 1426

Hide thumbs Also See for AXXESS:

Table of Contents

Appendix A — Networking

T1/PRI or T1/E1/PRI Cards

6.20 To program the T1/PRI or T1/E1/PRI cards:

Node Trunk Groups

6.21 To program the node trunk groups:

Node Trunk Lists

6.22 To add the node trunk groups to the node's list:

Off-Node Devices

6.23 There are two methods for programming off-node devices, as described on

The automatic broadcast method works only for newly created stations. Any extensions that

existed before the nodes began communicating must be exported (or imported) to other nodes

using the Export/Import button in DB Programming or programmed as "off-node devices"

manually at each of the other nodes.

MANUAL VERSION 11.0 – May 2008

In Cabinets, program the card slots and then program B-channels and extension num-

bers for the circuits.

Select the card to program. Then set the ISDN Switch Type to Private Network. This

will automatically place the trunks on this card in a node trunk group.

Set the Remote Node Number to the node where the T1 span will be connected. (This

span can also be used to route calls to other nodes, through the remote node, if the

remote node is properly programmed.)

If using an IP or frame relay device, such as the IP Networking Module, the

Remote Node Number can be set to any valid node number. The device will use this

field for identification purposes only.

In System\Devices and Feature Codes\Node Trunk Groups, select the node trunk group.

Name the node trunk group, set outgoing access assignments.

Repeat for the remaining node trunk groups.

In System\Devices and Feature Codes\Nodes, select the remote node.

Select Node Trunk Groups and add the node trunk groups.

Program the Search Algorithm.

Repeat for each node.

T1/PRI or T1/E1/PRI Cards

Chapters

Table of Contents