Inter-Tel AXXESS Manual page 1514

Appendix D — CPC64/CPU64 Configuration
® ®
INTER-TEL AXXESS
D. VOICE PROCESSING SOFTWARE INSTALLATION
4.17 The EVMC is shipped with OS/2 and the Voice Processing applications software
already installed on the hard disk drive. As a back-up, a CD containing the software is also
available. If the software is upgraded at a later time, a new CD will be available.
4.18 To upload the software to the EVMC you will need:
•
•
•
4.19 If you are using secondary language prompts, you will also need to do the following:
•
•
4.20 Use the following procedure to install the Voice Processing applications software via
floppy drive:
If the EVMC is not shut down properly before it is removed from the equipment chassis, the
database will probably become corrupted, and the EVMC will go into an endless rebooting
cycle.
1.
2.
3.
4.
5.
Page D-24
MANUAL VERSION 11.0 – May 2008
A set of Voice Processing software disks (make copies from the CD)
An external floppy drive (available in the Floppy Drive Kit 828.1486)
A keyboard and monitor
Copy the secondary language prompt files to floppy disks. This will require five disks.
The prompt files are located on the CPU64 software CD in the Axxess_64\CPU-
SOFT\EVMCSOFT\PROMPTS directory.
Make sure the Multilingual Support premium feature is licensed and select
in system DB Programming.
Language
Shut down the EVMC by using a small object to press the Power Down button on the
front edge of the card (see illustration on the previous page for its location). The EVMC
will go through a shutdown process and the "OK To Remove Card" LED will flash.
When shutdown is complete, the LED will be solidly lit.
NOTE:
When the "OK To Remove Card" LED turns green, it is safe to remove the
EVMC from the equipment chassis for the next 10 seconds. If you do not remove the
card within that amount of time, allow the card to reboot and wait for the "Card On-Line"
LED to light. Then you can repeat the shutdown process and remove the EVMC.
Remove the EVMC from the chassis and lay it on a clean, flat, anti-static surface.
When handling the EVMC be very careful not to damage the hard drive. It is sensi-
tive to vibration, pressure, and shock.
Attach the floppy drive cable to the floppy connector on the EVMC (see
page D-22 for location).
NOTE:
When plugging in the floppy drive or power connector ribbon cable, the red
stripe goes on the side closest to the power supply.
Attach the larger connector on the floppy drive power cable to the floppy drive.
Attach the other (smaller) connector on the floppy drive power cable to the floppy drive
power connector on the EVMC.
CAUTION
CAUTION
Voice Processing Software Installation
Secondary
Figure D-3 on