Inter-Tel AXXESS Manual page 939

Hide thumbs Also See for AXXESS:

Table of Contents

16.6 The new node is added to the Target Remote Node screen of the wizard. If you want to

network to this new node, select it from the list and click

database unless you select it as the target node and complete the networking wizard. If you cre-

ate the first remote node on the system using the networking wizard, DB Studio automatically

shuts down when you click Finish.

16.7 Selecting/Creating Networking Boards: The next screen of the networking wizard

allows you to select a networking board from the list of boards in the system. If you are config-

uring IPRC networking, a list of available IPRCs appears. If you are configuring T1/E1 net-

working, a list of available T1/E1 PRI Cards appears.

16.8 Select a board from the list and then click

able networking board, you can create and configure one by clicking

16.9 To create and configure a new IPRC:

below. The Board Type is pre-populated as Internet Protocol Resource Card, and cannot

Networking Wizard

Although the new node is available on the wizard's screen, it will not be added to the

IPRC Networking

Create/Update New Board

MANUAL VERSION 11.0 – May 2008

. If the system does not have an avail-

T1/E1 Networking

. The Create IP Board dialog box appears as shown

Create/Update New

Chapters

Table of Contents