Table D-11 Evmc Led Indications - Inter-Tel AXXESS Manual

Appendix D — CPC64/CPU64 Configuration
® ®
INTER-TEL AXXESS
C. HARDWARE INSTALLATION
When handling the EVMC be very careful not to damage the hard drive. It is sensitive to
vibration, pressure, and shock.
4.16 To install the EVMC, see
1.
2.
3.
4.
Table D-11.
Page D-20
MANUAL VERSION 11.0 – May 2008
Make sure the proper security PAL is installed in socket U23. (The PAL determines the
number of available mailboxes.)
NOTE:
Currently, the 4-port EVMC is shipped with the 32-mailbox PAL.
If installing a second DSPM Card, attach the DSPM card in the lower socket, below the
existing DSPM card. Make sure that the connectors and the standoffs are properly
aligned and seated.
Insert the EVMC into slot 7 of the equipment chassis.
Observe the LEDs on the front of the EVMC. The LED indications are as follows. (The
left LED is marked "CARD ON-LINE" and the right LED is marked "OK TO
REMOVE CARD.")
EVMC LED Indications
LED Indication
Both LEDs off
Left LED blinking slowly
Left LED blinking rapidly
Left LED lit solid
Right LED blinking rapidly
Right LED blinking slowly
Right LED lit solid
CAUTION
Figure D-3 on page D-22 and do the following:
If the system chassis is powered up, the OS/2
operating system is starting.
Voice Processing Unit is attempting to connect to
the CPC or CPU.
The OS/2 operating system and the Voice Process-
ing Unit driver have started.
Voice Processing Unit is initialized and connected
to the CPC or CPU.
Voice Processing Unit is shutting down.
Voice Processing Unit is shut down and the OS/2
operating system is shutting down.
Voice Processing Unit and OS/2 are shut down. It
is now safe to turn off power and remove the
EVMC from the chassis.
Meaning
Hardware Installation