Inter-Tel AXXESS Manual page 1104

Programming
® ®
INTER-TEL AXXESS
NOTE:
ID [CLIP], DID, ANI, or DNIS. If the trunk is programmed to collect digits, but the trunk group
does not use call routing tables, the system routes the call based on the trunk group program-
ming and ignores the collected digits. (However, the collected digits will appear in SMDR and
can be used by the Desktop Interface.) If the trunk is not set up to collect digits and the trunk
group uses call routing tables, the system uses the call routing destination for "no-digit" calls.
Service Type
4.369 (For Europe) This cannot be programmed unless the Advanced CO Interfaces premium
feature is licensed (see
trunks. When selected, the Caller ID [CLIP] service type option indicates that the associated
trunk will provide caller identification signals when used with a loop start adapter (LSA) and
an MGCP gateway (see the IP Devices Installation Manual, version 1.3 or later, for details). To
set the Service Type, select the current Value and scroll to the desired option. Then press
ENTER
NOTE:
Start Type
4.370 (E&M and DID only) E&M and DID trunks perform "handshaking" between the sys-
tem and the central office to transfer call information. The three start types are described
below. To set the Start Type select the current Value and scroll to the desired option. Then press
ENTER
•
•
•
•
DTMF Signaling In Band
4.371 (With a European system, this is used for Loop Start Trunks) Trunks can be set for
DTMF or dial pulse signals. To set the signaling method select the current Value and scroll to
the desired option. Then press
Disconnect Timer
4.372 (E&M and DID Only) The trunk can be programmed to uses the Disconnect timer for
disconnecting calls immediately whenever the inside party hangs up on a call. If the Discon-
nect timer is not enabled, it will wait up to 2 seconds for an on-hook signal from the central
office. To set the Disconnect Timer option select the current Value and scroll to the desired
option (Disconnect Timer or Wait for Remote On-Hook). Then press
the field to save your change.
Page 6-254
MANUAL VERSION 11.0 – May 2008
Each individual trunk, not the trunk group, is programmed to collect digits using Caller
page 6-97). The Service Type field is available only for loop start
or click outside the field to save your change.
Do not change the Service Type to Caller ID unless using IP LSAs.
or click outside the field to save your change.
Immediate: If programmed for "Immediate" start type, the calling system will immedi-
ately begin sending the dialed digits to the receiving system.
Wink: If programmed for "Wink" start type, the systems perform a "handshake" to
allow the receiving system to signal that it is ready to receive the digits dialed by the
other system. (This is the default start type.)
Delay Dial: If programmed for "Delay Dial" start type, the calling system will wait
until its E&M Dial Delay timer expires before sending any digits to the receiving sys-
tem.
Dial Tone: (E&M trunks only) If programmed for "Dial Tone" start type, the calling
system will wait until it detects dial tone from the other system before sending digits.
ENTER
or click outside the field to save your change.
or click outside
ENTER
Trunks