Inter-Tel AXXESS Manual page 1099

Hide thumbs Also See for AXXESS:

Table of Contents

4.354 To verify the "CO Timeout in seconds" timer value:

Programming. See

If you have not already done so, start DB Programming in OLM mode as described in

steps 1. through 3. on

From the left pane, select System – Trunk-Related Information –

default is 6 seconds.

After validating that the Print Expanded Message Print option is enabled and the CO

Timeout in seconds value is set to 4, click

able the option. You exit OLM mode and the regular DB Programming window dis-

plays. As appropriate, proceed either to the procedure to run a Hybrid Balance Test on a

single trunk or on all trunks. See

4.355 To activate the Message Print client:

From your Windows desktop, select Start – Inter-Tel DB Programming –

appears in the Diagnostics Monitor window.

Minimize the Diagnostics Monitor window until needed.

Proceed only if the "Print Expanded Message Print" capability has been enabled in DB

for details.

. Change the CO Timeout in seconds value to 4, if it is set to any other value. The

. The Diagnostics Monitor and New Connection windows display.

Message Print

MANUAL VERSION 11.0 – May 2008

and then click

. Scrolling Message Print output from the system

Hybrid Balance Set-

On-Line Monitor

Chapters

Table of Contents