Inter-Tel AXXESS Manual page 1276

Programming
® ®
INTER-TEL AXXESS
Table 6-46:
Voice Processor Timers and Limits (Continued)
Timer
Maximum Number of
Deleted Messages
Maximum Outgoing Calls
Minimum Call Progress
Silence Duration
Minimum Call Progress Sig-
nal Duration
Notification No-Answer
Detection
Page 6-426
MANUAL VERSION 11.0 – May 2008
Default Range
0 messages 0-9999
messages
2 calls 1-number of
ports
(max 32)
15 1-21
hundredths hundredths
(0.01-0.21
sec.)
18 1-18
hundredths hundredths
(0.01-0.18
sec.)
4 rings 1–25 rings
per prompt
iteration
1–5 prompt
iterations
(automatic)
Defines
The maximum number of deleted messages that
the Voice Processing Unit will store. If this number
is exceeded, and a user deletes a message, the
Voice Processing Unit will remove the oldest mes-
sage in storage to make room for the new one.
(Entering a value of 0 means that the number is
unlimited.) However, this limit is bound to the avail-
ability of hard disk space as specified by the Maxi-
mum Deleted Message Space above. That is, the
Maximum Deleted Message Space limitation will
take precedence over this one.
The number of outgoing message notification and
fax delivery calls that can be made at one time by
the Message Notification/Retrieval application. Note
that the number of calls that can be made are also
limited by the availability of intercom voice chan-
nels and outgoing trunks.
The minimum duration of a period of silence neces-
sary for the Voice Processing Unit to detect silence.
That is, if a period of sound is broken by silence,
and the silence is shorter than this timer, the Voice
Processing Unit will ignore the silence. This timer
applies to outgoing remote notification calls only.
NOTE:
This timer is not supported in Enterprise
Messaging.
The minimum duration of a period of sound neces-
sary for the Voice Processing Unit to detect sound.
That is, if a period of silence is broken by a burst of
sound on the line, and that sound is shorter than
this timer, the Voice Processing Unit will ignore the
sound. This timer applies to outgoing remote notifi-
cation calls only.
NOTE:
This timer is not supported in Enterprise
Messaging.
The Notification No-Answer Detection flag has two
purposes:
•
It sets the number of times remote messaging
will ring an IC call or CO call before assuming
a no answer condition (from 1 to 25)
•
It automatically sets the number of iterations
remote messaging will cycle through the
prompts asking for the correct person (from 1
to 5)
DB Programming allows a range of 1 - 25 for this
field. The maximum number of rings can be 25, but
the maximum prompt cycles is 5 regardless of the
field value.
Timers and Limits