Example Cisco Configuration Commands; Private Network With Near-End Nat Traversal - Inter-Tel AXXESS Manual

Hide thumbs Also See for AXXESS:

Table of Contents

15. EXAMPLE CISCO CONFIGURATION COMMANDS

15.1 The following commands are provided as an example to further illustrate the recom-

mended configuration with respect to security. Quality of Service (QoS) configuration is

beyond the scope of this appendix. These configuration examples are based on the Cisco

Firewall feature set. Adtran

NetVanta Switch/Router Example" on

These commands are not intended to be complete; they are only a guideline.

A. PRIVATE NETWORK WITH NEAR-END NAT TRAVERSAL

15.2 The following diagram shows a configuration example.

15.3 The following commands set up the connection to the internal LAN. NAT is enabled,

interface Ethernet0/0

description Internal LAN

ip address 192.168.1.1 255.255.255.0

ip access-group e0in in

ip nat inside

ip inspect inspector in

Example Cisco Configuration Commands

routers use a very similar command set called AOS. See "Adtran

for traffic coming in (to the router) from the internal LAN.

access-group e0in

Appendix F – Network Topology

MANUAL VERSION 11.0 – May 2008

for more information on Adtran routers.

Table of Contents