Inter-Tel AXXESS Manual page 1065

•
System Conditions (Day and Night Mode): The station can be programmed to use the
forwarding path when the system is in day mode and/or night mode. (In the default
state, both day and night mode are selected.) Indicate whether calls will follow the for-
warding path in day and/or night mode by enabling the desired system condition(s). To
enable a flag select the current Value and then select the check box to place a check in
it. Then press
and disable the flag, select the check box again.)
•
Forwarding Call Types: The types of calls that can be forwarded are listed below. The
forwarding station can be programmed to forward any or all of these call types. (In the
default state, call routing, ring-in, DISA, and transferred calls are enabled.) Determine
the types of calls that will follow the forwarding path by enabling each desired call
type. To enable a flag select the current Value and then select the check box to place a
check in it. Then press
the check and disable the flag, select the check box again.)
—
—
—
—
—
—
NOTE:
type (for example, multiple forwarding paths for outside calls). If one forwarding path is for the
"No Answer" call condition, it should be last on the list of forwarding paths for the station. If No
Answer is the condition in the first path, the system will always wait for the System Forward Ini-
tiate timer to expire before forwarding, even if the station is in do-not-disturb mode or busy.
IP Settings
4.237 (IP endpoints and IP SLAs only) After you have programmed the circuits and voice
channels for the IP devices (including IP SLAs), you must program the IP settings. The IP Set-
tings folder allows you to program the IP connection information for each device. The avail-
able fields are as follows:
4.238 Network Configuration (see below)
•
Network Group (see
•
Call Configuration (see
•
NAT Address Type (see
Stations on the Local Node
INTER-TEL
or select another field to save the change. (To remove the check
ENTER
ENTER
Call Routing Table: Outside calls received through a call routing table, including
DID and E&M [DDI in Europe] calls, but not including DISA calls
CO Ring-In: Ringing outside calls (including calls received through network con-
nections)
CO Transfer/AA/VM: Transferred outside calls (including automated attendant
and voice mail transfers and transfers from other nodes)
CO Recall: Recalling outside calls (including calls from other nodes)
DISA: DISA calls (including DISA calls received through a call routing table)
IC Calls: Intercom calls (including calls from other nodes)
Call forwarding paths are checked in numerical order when they apply to the same call
page 6-182)
page 6-185)
page 6-218)
® ®
AXXESS MANUAL VERSION 11.0 – May 2008
or select another field to save the change. (To remove
Programming
Page 6-215
6