Inter-Tel AXXESS Manual page 1063

•
Redial Mode: Station users can use last number dialed or last number saved redial
modes. This option can be programmed using this window only, it cannot be changed
by the station user. In the default state, the stations are set for dialed mode.
•
Ring Intercom Always: When this feature is enabled, all calls placed to phones from
this station are received as private calls. The feature can be enabled or disabled through
programming or by the phone user. In the default state, this feature is disabled.
•
Send Alert Burst To Headset: (Inter-Tel phones only) This flag, when enabled, will
send a single tone to a headset instead of normal phone ring tones when a call is ringing
at the station (non-handsfree intercom call, outside call, queue callback, or reminder
message). By default the flag is disabled.
•
Send T1 OPX Disconnect Flash: (T1 OPX Single-line station only) This flag, when
enabled, sends a proprietary disconnect signal from the T1 OPX to the loop start trunk.
(The "A" bit is toggled high for the duration of the SL Disconnect Flash Duration
timer.) At default, this flag is disabled. To remind you, a warning will be displayed in
DB Programming whenever the flag is changed. The warning states that the flag will
have no effect unless the correct T1 firmware is installed on the card. If your T1 card
does not have the proper firmware, there is an upgrade kit available. Although you can
enable this flag for all single lines, the flag is ignored unless the single-line set is a T1
OPX.
NOTE:
Inter-Tel system can be on the receiving end with T1 Loop Start channels and will rec-
ognize the disconnect. However, it cannot send the disconnect.
•
Standard Tone Frequencies: The busy tones and dial tones can be pure system tones
(as described in FEATURES,
match the telephone company's standard tones. In the default state, standard tones are
enabled (allowing standard telephone company type tones).
•
System Forwarding: When this option is enabled, calls to the station follow the system
forwarding path that is programmed for the station (if any). This option can be enabled
is the database or at the station. In the default state, it is enabled.
•
Transfer To Connect Allowed: (Inter-Tel phones only) If this flag is enabled, an
announced transfer call (including an announced transfer from voice mail) connects
immediately with the destination once the transferring party hangs up. (If the flag is dis-
abled, the recipient must press a CALL button to answer the transferred call). If the user
has a headset enabled, or if the station user picks up the handset for the initial call and
the transferring party disconnects, the transferred party will hear a single tone and then
be immediately connected without any further action from the station user. Calls will
not automatically connect in handsfree speakerphone mode; the user must press a
CALL button to answer the call. This flag is disabled by default.
•
Transient Call Indication On Call Answer: (Inter-Tel phones only) This flag deter-
mines whether the station user will see a call indication display when answering a call
by pressing a secondary extension button or by reverse transferring. If enabled, the dis-
play will tell if the call was ringing, recalling, transferred, or holding at the other sta-
tion. In the default state, it is enabled.
Stations on the Local Node
®
INTER-TEL AXXESS
This flag does not affect T1 channels configured for Loop Start. Therefore, an
page
®
MANUAL VERSION 11.0 – May 2008
5-172) or they can be changed to more closely
Programming
Page 6-213
6