Smdr Buffer - Inter-Tel AXXESS Manual

Programming
® ®
INTER-TEL AXXESS

11. SMDR BUFFER

NOTE:
11.1 The Voice Processor will buffer SMDR records from the local node and records that are
sent from other nodes in the network. The following information can be programmed for the
Voice Processor SMDR Buffering application.
•
•
•
•
11.2 Clear The SMDR Buffer: (Not available in stand-alone programming sessions.) Dur-
ing a direct-connect or remote programming session, you can clear the data in the SMDR
buffer. To clear the buffer, right-click on
select
Select
information window will appear to tell you that the buffer has been cleared. Select
tinue.
11.3 Programming the SMDR Buffer: You can program the following fields:
•
•
•
Page 6-422
MANUAL VERSION 11.0 – May 2008
SMDR buffering is not supported by Enterprise Messaging.
Clear SMDR Buffer
SMDR Buffer Size
SMDR Buffer-Box Bit Rate - COM 2
Enable SMDR Buffering
. A window appears that asks if you are sure you want to clear the SMDR buffer.
Clear
to continue or select
Yes Cancel
SMDR Buffer Size: To determine how much of the Voice Processing PC disk space
will be devoted to SMDR buffering, select the current value and enter or scroll to the
desired number of megabytes (0-20). Then press
save the change.
— If you attempt to set the buffer size to a value higher than your available disk
space, you will receive a warning message that says, "The Voice Processing PC
did not have enough disk space to set the buffer size to XXX megabytes. The cur-
rent buffer size is now 0 megabytes. Note: If there was data in the buffer, the data
is still intact."; select
— If you change the size of the buffer, a window appears that tell you that the buffer
will be cleared and asks if you want to continue. Select
ing or select to leave the buffer and buffer size unchanged.
No
SMDR Buffer Box Bit Rate: To determine the rate of output from the buffer box port
(COM2), select this drop-down list box. The available rates are 300, 1200, 2400, 4800,
9600, and 19200. Then press
Enable SMDR Buffering: (Buffer size must be greater than 0 for this check box to be
selected.) To enable the SMDR Buffering option, select the check box to place a check
mark in it. Then press
ENTER
SMDR buffering, select the check box again to remove the check mark.
in the Voice Processor directory and

SMDR Buffer

to leave the buffer unchanged. If you chose to clear, an
ENTER
to continue and reset the buffer to a valid size.
OK
or click on another field to save the change.
ENTER
or click on another field to save the change. To disable
to con-
OK
or click on another field to
to complete the resiz-
Yes
SMDR Buffer