Message Print - Inter-Tel AXXESS Manual

Programming
® ®
INTER-TEL AXXESS
D. MESSAGE PRINT
8.25 System messages can be printed to give service personnel and Inter-Tel engineers infor-
mation about system status during troubleshooting. You may enable any combination of the
error message types. The available message types are:
•
•
•
•
•
8.26 The fields you must program to set up message print include the following:
•
•
•
•
•
•
•
•
•
8.27 See FEATURES,
Print Diagnostics Manual (part number 550.8018—supplied on the software CD) for more
information regarding system messages and alarms.
8.28 Output Port And Local Backup Port: Each node has its own message print program-
ming, message print output port, and message print output port backup. There should be a mes-
sage print terminal at each node to monitor node and network performance and aid in
troubleshooting.
•
•
•
Page 6-274
MANUAL VERSION 11.0 – May 2008
Alarm Messages: Indicate that a minor alarm has occurred, but that general system
operation was not affected.
Information Messages: Provide information concerning system operation.
Severe Messages: Indicate that a severe error has occurred in the system.
Warning Messages: Indicate that a condition exists which may affect system perfor-
mance.
Network Dump: Provides information concerning network operation.
Output Port
Local Backup Port
Message Print Output Active
Output Device Line Width
Print Alarm Messages
Print Information Messages
Print Severe Messages
Print Warning Messages
Print Network Dump
page 5-313, or TROUBLESHOOTING,
If a node's Message Print output port is a node, the network sends Message Print
records to the specified node.
You cannot select a node as the backup message print output port.
If Message Print output programming forms a loop, the system will send the output to
the node's backup Message Print port. For example, if the Message Print port on Node
1 routes to Node 2 and the Message Print port on Node 2 routes to Node 1, the configu-
ration will cause an infinite loop. Message Print reports for Node 1 would be printed to
the backup serial port on Node 2 and vice versa.
page 7-12, and the Message

Message Print