Inter-Tel AXXESS Manual page 1335

Table 7-16. Voice Processing Troubleshooting Chart (Continued)
Symptom
Unable to access desired
Voice Processing application
(intercom callers hear reorder
tones and see a XXXXX IS
UNAVAILABLE display; out-
side callers are rerouted to
the primary attendant)
Unable to access desired
Voice Processing application
(intercom callers hear reorder
tones and see a XXXXX IS
UNPLUGGED display; out-
side callers are rerouted to
the primary attendant)
Voice Processing applications
are slow (e.g., voice prompts
are slow and display mes-
sages are delayed)
Voice Processing PC is pro-
grammed with 12-32 voice
channels, but no more than
eight calls at a time are
accepted
When power is turned on, the
Voice Processing PC does
not boot up properly
Voice Processing Issues
®
INTER-TEL
Possible Cause
A database save or restore is
in progress, the PC is being
reset, or the PC is starting up
for the first time
The Voice Processing PC
power switch is off, the
cabling between the system
and the PC is disconnected
or defective, or the Voice
Processing PC is inoperative
The Voice Processing PC's
high-speed (turbo) processor
mode is turned off
The OPC is not programmed
to have a Voice Processing
Unit connection
The number of programmed
voice channels is less than
the available hardware
Loose/defective cabling
between the Voice Process-
ing Unit AIC and the chassis
OPC
AIC in slave chassis
Diskette in floppy drive
The two-pin AIC-to-reset
switch cable is not connected
properly
The DB-25 modular adapter
(supplied with the Voice Pro-
cessing PC) is still connected
to the COM2 serial port on
the PC
The Voice Processing PC's
high-speed (turbo) processor
mode is turned off
®
AXXESS MANUAL VERSION 11.0 – May 2008
Corrective Action
Try again within five or ten minutes.
Check to make sure the Voice Processing PC
power switch is on, and check the cabling connect-
ing the system to the PC.
For optimal performance, the Voice Processing PC
is configured with the high-speed (turbo) mode
always enabled. Do not disable the turbo mode
setting.
Configure the OPC to have a Voice Processing
Unit connection. See PROGRAMMING,
117.
Make sure the appropriate time slot group (number
of Voice Processing voice channels) is assigned to
each Voice Processing application. See PRO-
GRAMMING, page 6-354.
Check the AIC-to-OPC cabling.
In tri-/quad-chassis installations, make sure the
OPC is installed in the master dual-chassis.
Ensure that the PC is not trying to boot off a dis-
kette in the floppy drive.
Be sure that pin 1 marked on each end of the
cable matches pin 1 on the AIC and PC Mother
board. (If connected incorrectly, the PC will be
reset continuously or will not boot up at all.)
Remove the DB-25 modular adapter when not
being used
The Voice Processing PC boots up much faster in
turbo mode. Before shipping, the PC is configured
with the high-speed (turbo) mode always enabled.
Do not disable the turbo mode setting.
Troubleshooting
page 6-
Page 7-55
7