Inter-Tel AXXESS Manual page 1180

Programming
® ®
INTER-TEL AXXESS
Table 6-38: System
Timers (Continued)
Timer
DID Disconnect Recogni-
tion
DID Inpulse-dial Inter-
digit Pause Recognition
DID Off-hook Debounce
DID On-hook Debounce
DID Post-Seize Delay
DID Post-Signal Delay
DID Pre-Signal Delay
DID Ready Timeout
DID Seizure Recognition
DID Signal Hold
DISA Invalid Extension
Failure Limit
DISA Security Code Fail-
ure Limit
Page 6-330
MANUAL VERSION 11.0 – May 2008
Default
Range
Value
150 2-500 millisec.
(0.002-0.5 sec.)
240 2-500 millisec.
(0.002-0.5 sec.)
10 2-500 millisec.
(0.002-0.5 sec.)
12 2-500 millisec.
(0.002-0.5 sec.)
64 2-500 millisec.
(0.002-0.5 sec.)
30 2-500 millisec.
(0.002-0.5 sec.)
100 2-500 millisec.
(0.002-0.5 sec.)
4000 2-65000 millisec
(0.002-65 sec.)
30 2-500 millisec.
(0.002-0.5 sec.)
200 2-500 millisec.
(0.002-0.5 sec.)
3 0-9
3 0-9
Purpose
This is the minimum amount of time the circuit must
be on hook for the system to recognize that the call
has been disconnected.
This is the minimum pause allowed between in-com-
ing pulse-dial signals sent from the remote circuit. It
allows the system to recognize the separation
between digits.
This is the minimum amount of time the circuit must
be off hook before the system will recognize another
on-hook/off-hook transition.
This is the minimum amount of time the circuit must
be on hook before the system will recognize another
on-hook/off-hook transition
This is the minimum time allowed between the recog-
nition of a seizure and the beginning of digit valida-
tion. Used only for Immediate-Dial circuits.
This is the minimum time allowed between the end of
a handshake and the beginning of digit validation.
Used only for Wink-Start and Dial-Delay circuits.
This is the amount of time that must elapse between
the recognition of a trunk seizure and the handshake.
Used only for Wink-Start and Dial-Delay circuits. This
is the maximum time the T1 or T1/E1/PRI Card or
SLA will wait for the "Digit Register Ready" com-
mand. If the timer expires, the SLA or card will auto-
matically initiate a handshake. Used only for Wink-
Start and Dial-Delay circuits
This is the minimum amount of time the circuit must
be on hook for the system to recognize that the trunk
has been seized.
This is the maximum duration of a wink-start hand-
shake or the minimum duration of a dial-delay hand-
shake. Used only for Wink-Start and Dial-Delay
circuits.
This determines how many times a caller will be
allowed to enter an incorrect DISA security code with-
out being dropped. To program the failure limit, enter
the desired number in the text box. Entering 0 will
allow unlimited attempts.
This determines how many times a DISA caller will
be allowed to dial an invalid extension number before
being sent to the primary attendant. To program the
limit, enter the desired number in the text box. Enter-
ing 0 will allow unlimited attempts.
System Timers and Limits