Inter-Tel AXXESS Manual page 593

Create a trunk group that contains the E&M trunk(s) and program it to ring in to the
5.
Call Routing Table created above. See
MING.
Program the individual trunks. See
6.
PROGRAMMING. For E&M Trunk programming instructions. If marked for DID ser-
vice, program the numbers to match the Call Routing Table created above.
F. BASIC RATE INTERFACE (BRI) TRUNKS
NOTE:
10.51 ISDN BRI trunks enable the system to connect to video, voice, and data devices such as
video conference units, ISDN modems, LAN bridges, and ISDN telephones. The BRI cards
provide a cost-effective alternative to PRI for large and small systems requiring ISDN services.
10.52 BRI trunks provide the following basic rate features:
•
Support BRI stations that connect to data/video devices behind the PBX via BRS card
with an S interface and a BRU card with a U interface.
•
Support BRI trunks that connect to the network via BRS cards with an NT1 device.
•
Support data/video switching from behind the PBX out any U interface trunk (e.g., PRI
trunk and BRI trunk) to the public network.
10.53 BRI stations operate like other stations with the following exceptions:
•
BRI station ports do not support passive bus configuration (one ISDN device per BRS
port)
•
A BRI station does not have the ability to perform features while connected on a call
that require a hookswitch or SPCL button, including Individual Hold, System Hold,
Transfer, Record-A-Call, and Conference.
•
The BRI station cannot have a mailbox, but can have an extension ID
•
A message cannot be left for a BRI station.
•
Centrex options are not supported behind the BRS or BRU card.
•
Caller ID [CLIP] information does not include the caller's name (i.e., only the caller's
number is available).
10.54 A BRI station cannot place a call on both B-channel stations with a single setup mes-
sage. The bonding must be performed outside the D-channel signaling. In other words, a video
conference unit or data device must place two separate calls and perform the bonding at the
external device level. The routing user information provided on the D-channel at this time is
call setup and call termination messages only.
Basic Rate Interface (BRI) Trunks
INTER-TEL
This requires the Advanced CO Interfaces software license and a BRS or BRU card.
® ®
AXXESS MANUAL VERSION 11.0 – May 2008
page 6-228 (Trunk Groups) in PROGRAM-
page 6-244 (Individual Trunk Programming) in
System Features
Page 5-67
5