Subaru IMPREZA GD 2007 Series Manual page 3764

asieps_tobira_IM_US.book 23 ページ ２０１２年１月１７日 火曜日 午後３時４８分
B: INSTALLATION
1. REAR GATE PANEL
1) Install in the reverse order of removal.
2) Install the rear gate with uniform clearance to the
body.
Tightening torque:
Refer to "COMPONENT" of "General Descrip-
tion". <Ref. to EB-10, TRUNK LID PANEL,
COMPONENT, General Description.>
CAUTION:
Do not damage the painted surfaces of body
and rear gate panel.
2. REAR GATE DAMPER STAY
1) Install the mounting bolt (A) to the rear gate and
body.
Tightening torque:
19.6 N·m (2.0 kgf-m, 14.5 ft-lb)
2) Securely install the rear gate damper stay (B) to
the mounting bolt (A).
(B)
NOTE:
Before starting work, support the rear gate with a
support jack.
Rear Gate
(A)
EB-00131
EB-23
EXTERIOR BODY PANELS
C: DISPOSAL
1. REAR GATE DAMPER STAY
CAUTION:
Gas is colorless, odorless, and harmless. How-
ever, gas pressure may spray cutting powder or
oil. Be sure to wear dust-resistant goggles.
1) Cover with a vinyl sack as shown in the figure.
(1)
(1) Rear gate damper stay
(2) Vinyl sack
NOTE:
Prevent the vinyl sack from being caught by drill
cutting edge.
2) Lift the body side slightly with piston rods fully
extended, and secure the body side with vise.
Drill a hole in 2 to 3 mm (0.08 to 0.12 in) diameter at
a point 10 to 200 mm (0.39 to 7.87 in) from door
side, and bleed rear gate damper stay gas stay
completely.
(1)
(5)
(6)
(1) Body side
(2) Door side
(3) 190 mm (7.48 in)
(4) 10 mm (0.39 in)
(5) Piston rod
(6) Cylinder
(7) Portion to be drilled
(2)
EB-00031
(2)
(3) (4)
(7)
EB-00032