Subaru IMPREZA GD 2007 Series Manual page 3795

asieps_tobira_IM_US.book 30 ページ ２０１２年１月１７日 火曜日 午後３時４８分
EXTERIOR/INTERIOR TRIM
Process
Process name
No.
Cleaning/
18
degreasing
19 Top coat (I)
20 Leave unattended Not required.
21 Top coat (II)
22 Drying
23 Inspection
Removal of
24
masking
25 Parts installation
Bumper
26
installation
Front Bumper
Same as Process No. 12.
Non-colored
Use a "block" coating method.
• Recommended paint:
Suncryl (SC)
No. 307 Flex Hardener
SC Reducer (thinner)
• Mixture ratio: 3:1
Suncryl (SC) : No. 307 Flex Hardener
• Viscosity: 11 — 13 sec./20°C (68°F)
• Coating film thickness: 40 — 50 µ
• Spraying pressure: 245 — 343 kPa
2
(2.5 — 3.5 kgf/cm , 36 — 50 psi)
Not required.
Allow the coated surface to dry for two hours at 20°C (68°F) or 30 minutes at 60°C (140°F).
NOTE:
Do not allow the temperature to exceed 80°C (176°F) since this will deform the PP substrate.
Carefully check the condition of the repaired area.
Remove the masking tape applied in Process No. 11 and 13.
Install parts on the bumper in reverse order of removal.
Install the bumper.
EI-30
Job contents
Metallic paint
Use a "block" coating method.
• Recommended paint:
Suncryl (SC)
No. 307 Flex Hardener
SC Reducer (thinner)
• Mixture ratio: 3:1
Suncryl (SC) : No. 307 Flex Hardener
• Viscosity: 11 — 13 sec./20°C (68°F)
• Coating film thickness: 20 — 30 µ
• Spraying pressure: 245 — 343 kPa
2
(2.5 — 3.5 kgf/cm , 36 — 50 psi)
Leave unattended at 20°C (68°F) for at least 10
minutes until the topcoated area is half-dry.
NOTE:
Be careful to keep dust or dirt from coming in
contact with the affected area.
Apply a clear coat three times at an interval of 3
to 5 minutes.
• Recommended paint:
SC710 Overlay Clear
No. 307 Flex Hardener
SC Reducer (thinner)
• Mixture ratio: 3:1
Suncryl (SC) : No. 307 Flex Hardener
• Viscosity: 10 — 13 sec./20°C (68°F)
• Coating film thickness: 20 — 30 µ
• Spraying pressure: 245 — 343 kPa
2
(2.5 — 3.5 kgf/cm , 36 — 50 psi)