Show Ip Igmp Snooping Mrouter - Dell C9000 Series Reference Manual

Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.10(0.0)
9.9(0.0)
9.5(0.1)
9.2(0.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
7.6.1.0
7.5.1.0
Usage Information This command enables the IGMP switch to send General Queries periodically. This
behavior is useful when there is no multicast router present in the VLAN because the
multicast traffic is not routed. Assign an IP address to the VLAN interface for the switch
to act as a querier for this VLAN.

show ip igmp snooping mrouter

Display multicast router interfaces.
C9000 Series
Syntax
show ip igmp snooping mrouter [vlan number]
Parameters
vlan number
Command Modes
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
Description
Introduced the Configuration Terminal Batch mode on C9010.
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Enter the keyword vlan then the vlan number. The range is
from 1 to 4094.
• EXEC
• EXEC Privilege
Internet Group Management Protocol (IGMP) 1151