Rear Door Lock Assembly Components; Rear Door Lock Assembly Removal And Installation; Rear Door Lock Assembly Inspection - Suzuki SX4 Service Manual

9F-10 Security and Locks:

Rear Door Lock Assembly Components

1. Outside handle
: Apply lithium grease 99000-25011 to sliding part.
2. Outside handle frame
: Apply lithium grease 99000-25011 to sliding part and spring.
3. Rear door latch assembly
: Apply lithium grease 99000-25011 to sliding part.
Rear Door Lock Assembly Removal and
Installation
Removal
1) Remove rear door glass referring to "Rear Door
Glass Removal and Installation in Section 9E".
2) Disconnect door lock motor lead wire.
3) Remove door latch mounting screws (1) and remove
door latch assembly (2).
Installation
Reverse removal procedure to install rear door lock
assembly referring to the following instruction and "Front
Door Lock Assembly Removal and Installation".
• Tighten door latch screw to specified torque.
Tightening torque
Door latch screw (a): 5.0 N·m (0.5 kgf-m, 4.0 lb-ft)
6
1
5
S7RW0A9606008
2
1
I4RS0A960013-01
2
3
4. Latch striker
5. Inside handle bezel
6. Out side handle cap
• Install door trim referring to "Rear Door Glass
Removal and Installation in Section 9E".

Rear Door Lock Assembly Inspection

• Check that door opens and closes smoothly and
properly.
• Check that door stops in the secondary latched
position properly (preventing door from opening
freely) and that door closes completely in the fully
latched position.
• Adjust door latch striker position referring to "Front
Door Lock Assembly Removal and Installation", if
necessary.
S7RW0A9606007
(a)
4
(b)
I5RW0A960006-01
: 5.0 N⋅m (0.5 kgf-m, 4.0 lb-ft)
: 10 N⋅m (1.0 kgf-m, 7.5 lb-ft)
(a)
I4RS0A960014-01
S7RW0A9606009