Trunk Lid Lock Assembly Inspection (Sedan Model); Replacement Of Transmitter Battery (Other Than Keyless Start Model); Programming Transmitter Code For Keyless Entry System (Other Than Keyless Start Model) - Suzuki SX4 Service Manual

Trunk Lid Lock Assembly Inspection (Sedan
Model)
• Check that trunk lid opens and closes smoothly and
properly.
• Adjust trunk lid latch striker position referring to "Front
Door Lock Assembly Removal and Installation", if
necessary.
Replacement of Transmitter Battery (Other than
Keyless Start Model)
NOTE
For keyless start model, perform
"Replacement of Remote Controller Battery
in Section 10E" instead of "Replacement of
Transmitter Battery (Other than Keyless Start
Model)".
If transmitter becomes unreliable, replace transmitter
battery as follows.
1) Remove screw (1) and transmitter cover (2).
2) Remove transmitter (3) from transmitter holder (4).
CAUTION
!
Use care not to allow grease or dirt to be
attached on the printed circuit board and the
battery.
3) With tip of flat blade screwdriver put in slot of
transmitter, pry it open.
4) Replace the battery (lithium disc-type CR 1620 or
equivalent battery) so its (+) terminal faces "+" mark
on transmitter.
5) Fit together transmitter (3) and install it into
transmitter holder (4).
6) Install transmitter cover (2) and screw (1).
7) Make sure that door locks can be operated with
transmitter.
NOTE
• To prevent theft, be sure to break the
transmitter before discarding it.
S7RW0A9606022
S7RW0A9606014
4
3
2
1
I4RS0B960014-01
• Dispose of the used battery properly
according to applicable rules or
regulations. Do not dispose of lithium
batteries with ordinary household trash.
Programming Transmitter Code for Keyless
Entry System (Other than Keyless Start Model)
NOTE
• Three transmitter codes can be registered.
• When a new transmitter code is registered,
the oldest one will be cleared.
• For keyless start model, perform
"Registration Procedure for Remote
Controller ID Code in Section 10E" instead
of "Programming Transmitter Code for
Keyless Entry System (Other than Keyless
Start Model)".
If transmitter or BCM (included in junction block
assembly) is replaced or additional transmitter(s) is
necessary, program transmitter code(s).
1) Confirm that all doors are closed and ignition key is
out of ignition key cylinder.
2) Open driver side door.
3) Turn ignition switch to ON position, and then drawn
ignition key from ignition key cylinder within 10
seconds after that.
4) Push and release driver side door switch (1) at 3
times by hand within 20 seconds after removing
ignition key from ignition key cylinder.
5) Turn ignition switch to ON position, and then drawn
ignition key from ignition key cylinder within 10
seconds after that. All doors automatically lock and
unlock once.
With this, registration mode.
6) Push "UNLOCK" button (2) on transmitter (3) within
20 seconds after Step 5). All doors automatically lock
and unlock once.
With this, code registration is completed.
7) If an additional transmitter, needs to be programed
repeat the procedure of Step 1).
Security and Locks: 9F-15
S7RW0A9606015
1
2
3
I4RS0B960010-01