Suzuki SX4 Service Manual page 1507

5) Disconnect door opening control rod (1) from outside
handle.
6) Disconnect door lock motor lead wire at coupler.
7) Remove door latch screws (2) and remove door lock
assembly (3).
Installation
Reverse removal procedure to install front door lock
assembly noting the following instructions.
• Apply grease to sliding parts of door latch assembly.
: Grease 99000–25011 (SUZUKI Super Grease A)
• Tighten door latch screws to specified torque.
Tightening torque
Door latch screw (a): 5.0 N·m (0.5 kgf-m, 4.0 lb-ft)
3
1
2
I4RS0A960006-01
(a)
I4RS0A960008-01
• Move door latch striker (2) up or down so its center
aligns with the center of groove "A" on the door lock
assembly (1) as shown.
Striker should be moved vertically and placed level.
Do not adjust door lock (1).
Tightening torque
Door latch striker screw (a): 10 N·m (1.0 kgf-m, 7.5
lb-ft)
1
3. Shaft
• Move door latch striker (1) sideways to adjust door
outer panel surface (2) flush with rear door outer
panel or body outer panel surface (3) as shown.
[A]: Front door
• Install door trim referring to "Front Door Glass
Removal and Installation in Section 9E".
Security and Locks: 9F-7
2
"A"
3
(a)
I5RW0A960005-01
I5RW0A960012-01
[B]: Rear door