Policy Action Mirror - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

Hide thumbs Also See for OmniSwitch 6250:

Table of Contents

QoS Policy Commands

policy action mirror

Mirrors ingress packets that match a mirroring policy to the specified port.

policy action action_name ingress mirror slot/port

policy action action_name no mirror slot/port

Syntax Definitions

Platforms Supported

OmniSwitch 6250

Usage Guidelines

Use the no form of the command to remove mirror from the policy action.

Use this command to configure a mirror-to-port (MTP) action that is used for policy based mirroring.

Only one MTP session is supported at any given time. As a result, all mirroring policies should specify

the same MTP port.

Policy based mirroring and the port based mirroring feature can run simultaneously on the same

switch. If a packet qualifies for both types of sessions, the packet is copied to the destination for both

-> policy action a1 mirror 1/7 (default ingress)

-> policy action a1 ingress mirror 1/7

-> policy action a1 no mirror

Release History

Release 6.6.1; command was introduced.

OmniSwitch CLI Reference Guide

The name of the action.

Mirrors ingress packets.

The slot and port number that will receive the mirrored traffic.

November 2009