Ip Nat Inside Source List - Juniper JUNOSE SOFTWARE 11.0.X - COMMAND REFERENCE A TO M 1-11-2010 Command Reference Manual

JUNOSe 11.0.x Command Reference Guide A to M

ip nat inside source list

ip nat inside source list accessListName pool poolName [ overload ]
Syntax
no ip nat inside source list accessListName
Command introduced before JUNOSe Release 7.1.0.
Release Information
Creates dynamic translation rules that are applied to a source address when routing
Description
a packet from the inside network to the outside network, and for translating the
destination address when a packet returns from the outside network to the inside
network. The no version removes the dynamic translation rule.
NOTE: This command does not remove any dynamic translations from the translation
table.
Options
Global Configuration
Mode
854
ip nat inside source list
accessListName Name of the access list that you want to use for this dynamic
translation
poolName Name of the NAT IP address pool that contains addresses you want
to use when translating matched access list addresses
overload Specifies that the translation process create extended translation table
entries (IP address, protocol, and port values)