Configuring Gvrp Port Registration Mode; Displaying And Maintaining Gvrp - 3Com WX3000 Series Operation Manual

Table 1-2 Relations between the timers
Timer
Hold
Join
Leave
LeaveAll

Configuring GVRP Port Registration Mode

Follow these steps to configure GVRP port registration mode:
To do...
Enter system view
Enter Ethernet port view
Configure GVRP port
registration mode

Displaying and Maintaining GVRP

To do...
Display GARP statistics
Display the settings of the
GARP timers
Display GVRP statistics
Display the global GVRP status
Clear GARP statistics
Lower threshold
10 centiseconds
This lower threshold is greater
than or equal to twice the
timeout time of the Hold timer.
You can change the threshold
by changing the timeout time of
the Hold timer.
This lower threshold is greater
than twice the timeout time of
the Join timer. You can change
the threshold by changing the
timeout time of the Join timer.
This lower threshold is greater
than the timeout time of the
Leave timer. You can change
threshold by changing the
timeout time of the Leave timer.
Use the command...
system-view
interface interface-type
interface-number
gvrp registration { fixed |
forbidden | normal }
Use the command...
display garp statistics
[ interface interface-list ]
display garp timer [ interface
interface-list ]
display gvrp statistics
[ interface interface-list ]
display gvrp status
reset garp statistics
[ interface interface-list ]
Upper threshold
This upper threshold is less than or equal to
one-half of the timeout time of the Join timer. You
can change the threshold by changing the
timeout time of the Join timer.
This upper threshold is less than one-half of the
timeout time of the Leave timer. You can change
the threshold by changing the timeout time of the
Leave timer.
This upper threshold is less than the timeout time
of the LeaveAll timer. You can change the
threshold by changing the timeout time of the
LeaveAll timer.
32,765 centiseconds
—
—
Optional
By default, GVRP port
registration mode is normal.
You can execute the display
command in any view.
You can execute the reset
command in user view
1-6
Remarks
Remarks