Honda Accord 2008 Manual page 558

07/11/02 09:12:01 61TA0000_110_0239
12. Check for continuity between ECM/PCM connector
terminal C20 and throttle body 6P connector
terminal No. 1.
＊０２
TPSA (RED/BLK)
ECM/PCM CONNECTOR C (49P) TPSA (RED/BLK)
Is there continuity?
YES
NO −
body and the ECM/PCM (C20), then go to step 20.
13. Turn the ignition switch to LOCK (0).
14. Disconnect the throttle body 6P connector.
15. Jump the SCS line with the HDS.
16. Disconnect ECM/PCM connector C (49P).
THROTTLE BODY 6P CONNECTOR
Wire side of female terminals
Terminal side of female terminals
−
Go to step 25.
Repair open in the wire between the throttle
17. Check for continuity between ECM/PCM connector
terminal C43 and throttle body 6P connector
terminal No. 4.
THROTTLE BODY 6P CONNECTOR
SG3 (GRN)
Wire side of female terminals
ECM/PCM CONNECTOR C (49P)
SG3 (GRN)
Terminal side of female terminals
Is there continuity?
YES − Go to step 25.
NO − Repair open in the wire between the throttle
body and the ECM/PCM (C43), then go to step 20.
18. Turn the ignition switch to LOCK (0).
19. Replace the throttle body (see page 11-388).
20. Reconnect all connectors.
21. Turn the ignition switch to ON (II).
22. Reset the ECM/PCM with the HDS.
＊０３
(cont'd)
11-239