Honda Accord 2008 Manual page 486

07/11/02 09:09:12 61TA0000_110_0167
10. Check for continuity between ELD 3P connector
terminal No. 2 and body ground.
＊０３
Is there continuity?
YES
−
NO
G301 (see page 22-28), then go to step 12.
11. Replace the ELD (see page 11-230).
12. Reconnect all connectors.
13. Turn the ignition switch to ON (II).
14. Reset the ECM/PCM with the HDS.
15. Do the ECM/PCM idle learn procedure (see page
11-343).
16. Check for Temporary DTCs or DTCs with the HDS.
Is DT C P1298 indicated?
YES
NO −
Temporary DTCs or DTCs are indicated, go to the
indicated DTC's troubleshooting.
ELD 3P CONNECTOR
GND (BLK)
Wire side of female terminals
− Go to step 11.
Repair open in the wire between the ELD and
−
Go to step 17.
Troubleshooting is complete. If any other
17. Update the ECM/PCM if it does not have the latest
software (see page 11-231), or substitute a known-
good ECM/PCM (see page 11-7).
18. Check for Temporary DTCs or DTCs with the HDS.
Is DT C P1298 indicated?
−
YES Check for poor connections or loose
terminals at the ELD and the ECM/PCM. If the ECM/
PCM was updated, substitute a known-good ECM/
PCM (see page 11-7), then recheck. If the ECM/PCM
was substituted, go to step 1.
−
NO If the ECM/PCM was updated, troubleshooting
is complete. If the ECM/PCM was substituted,
replace the original ECM/PCM (see page 11-232). If
any other Temporary DTCs or DTCs are indicated,
go to the indicated DTC's troubleshooting.
11-167