07/11/02 09:05:53 61TA0000_110_0141
31. Monitor the OBD STATUS for DTC P050B in the
DTCs MENU with the HDS.
Does the screen indicate PASSED?
YES
−
Troubleshooting is complete. If any other
Temporary DTCs or DTCs were indicated in step 30,
go to the indicated DTC's troubleshooting.
−
NO
If the screen indicates FAILED, check for poor
connections or loose terminals at the CKP sensor,
the throttle body, the MAF sensor/IAT sensor, ECT
sensor 1, ECT sensor 2, and the ECM/PCM, then go
to step 1. If the screen indicates EXECUTING, keep
idling until a result comes on. If the screen
indicates OUT OF CONDITION or NOT COMPLETED,
go to step 28.
32. Update the ECM/PCM if it does not have the latest
software (see page 11-231), or substitute a known-
good ECM/PCM (see page 11-7).
33. Do the ECM/PCM idle learn procedure (see page
11-343).
34. Let the engine cool until the value of ECT SENSOR
1 is 122 °F (50 °C) or less.
35. Start the engine, and let it idle for 10 seconds or
more.
36. Check for Temporary DTCs or DTCs with the HDS.
Is DT C P050B indicated?
YES
−
Check for poor connections or loose
terminals at the CKP sensor, the throttle body, the
MAF sensor/IAT sensor, ECT sensor 1, ECT sensor
2, and the ECM/PCM. If the ECM/PCM was updated,
substitute a known-good ECM/PCM (see page 11-7),
then go to step 34. If the ECM/PCM was substituted,
go to step 1.
−
Go to step 37.
NO
37. Monitor the OBD STATUS for DTC P050B in the
DTCs MENU with the HDS.
Does the screen indicate PASSED?
YES
−
If the ECM/PCM was updated,
troubleshooting is complete. If the ECM/PCM was
substituted, replace the original ECM/PCM
(see page 11-232). If any other Temporary DTCs or
DTCs were indicated in step 36, go to the indicated
DTC's troubleshooting.
NO
−
If the screen indicates FAILED, check for poor
connections or loose terminals at the CKP sensor,
the throttle body, the MAF sensor/IAT sensor, ECT
sensor 1, ECT sensor 2, and the ECM/PCM. If the
ECM/PCM was updated, substitute a known-good
ECM/PCM (see page 11-7), then go to step 34. If the
ECM/PCM was substituted, go to step 1. If the
screen indicates EXECUTING, keep idling until a
result comes on. If the screen indicates OUT OF
CONDITION or NOT COMPLETED, go to step 34.
11-141