Honda Accord 2008 Manual page 470

07/11/02 09:05:55 61TA0000_110_0151
9. Measure voltage between output shaft
(countershaft) speed sensor 3P connector terminals
No. 1 and No. 3.
＊０３
VCC1 (YEL/RED)
Is there about 5 V ?
YES
NO −
(C14) and the output shaft (countershaft) speed
sensor, then go to step 18.
10. Turn the ignition switch to LOCK (0).
11. Jump the SCS line with the HDS.
12. Disconnect ECM connector B (49P).
OUTPUT SHAFT (COUNTERSHAFT)
SPEED SENSOR 3P CONNECTOR
SG1 (GRN/WHT)
Wire side of female terminals
−
Go to step 16.
Repair open in the wire between the ECM
13. Check for continuity between ECM connector
terminal B38 and body ground.
ECM CONNECTOR B (49P)
Terminal side of female terminals
Is there continuity?
YES − Repair short in the wire between the ECM
(B38) and the output shaft (countershaft) speed
sensor, then go to step 18.
NO − Go to step 14.
14. Connect output shaft (countershaft) speed sensor
3P connector terminal No. 2 to body ground with a
jumper wire.
OUTPUT SHAFT (COUNTERSHAFT)
SPEED SENSOR 3P CONNECTOR
NC (BLK/WHT)
JUMPER WIRE
Wire side of female terminals
NC (BLK/WHT)
(cont'd)
11-151
＊０４
＊０５