07/11/02 09:12:01 61TA0000_110_0237
11. Turn the ignition switch to LOCK (0).
12. Jump the SCS line with the HDS.
13. Disconnect ECM/PCM connector C (49P).
14. Disconnect the throttle body 6P connector.
15. Check for continuity between ECM/PCM connector
terminal C12 and throttle body 6P connector
terminal No. 2.
*03
VCC3 (BLU)
Is there continuity?
YES
NO
−
body and the ECM/PCM (C12), then go to step 18.
16. Turn the ignition switch to LOCK (0).
17. Replace the throttle body (see page 11-388).
18. Reconnect all connectors.
19. Turn the ignition switch to ON (II).
20. Reset the ECM/PCM with the HDS.
THROTTLE BODY 6P CONNECTOR
VCC3 (BLU)
Wire side of female terminals
ECM/PCM CONNECTOR C (49P)
Terminal side of female terminals
−
Go to step 23.
Repair open in the wire between the throttle
21. Do the ECM/PCM idle learn procedure (see page
11-343).
22. Check for Temporary DTCs or DTCs with the HDS.
Is DT C P0122 indicated?
YES
−
Check for poor connections or loose
terminals at the throttle body and the ECM/PCM,
then go to step 1.
NO
−
Troubleshooting is complete. If any other
Temporary DTCs or DTCs are indicated, go to the
indicated DTC's troubleshooting.
23. Reconnect all connectors.
24. Update the ECM/PCM if it does not have the latest
software (see page 11-231), or substitute a known-
good ECM/PCM (see page 11-7).
25. Check for Temporary DTCs or DTCs with the HDS.
Is DT C P0122 indicated?
YES
−
Check for poor connections or loose
terminals at TP sensor A and the ECM/PCM. If the
ECM/PCM was updated, substitute a known-good
ECM/PCM (see page 11-7), then recheck. If the
ECM/PCM was substituted, go to step 1.
NO
−
If the ECM/PCM was updated, troubleshooting
is complete. If the ECM/PCM was substituted,
replace the original ECM/PCM (see page 11-232). If
any other Temporary DTCs or DTCs are indicated,
go to the indicated DTC's troubleshooting.
11-237