Toyota Tundra 2005 Service - Repair - Maintenance page 2295

MT−52
Inner
Inner
MANUAL TRANSMISSION (RA60)
INSPECTION
Middle
1.
Outer
(a)
D13950
If the clearance is less than the minimum, replace the synchro-
nizer ring set No.1.
(b)
D13951
2.
Middle
(a)
Outer
D13950
If the clearance is less than the minimum, replace the synchro-
nizer ring set No.2.
− COUNTER GEAR
INSPECT SYNCHRONIZER RING SET NO.1
Using a feeler gauge, measure the clearance between
the synchronizer ring set No.1 and the 1st gear.
Standard clearance:
Inner: 1.48 to 2.12 mm (0.0583 to 0.0835 in.)
Middle: 0.68 to 1.92 mm (0.0268 to 0.0756 in.)
Outer: 0.88 to 1.72 mm (0.0346 to 0.0677 in.)
Minimum clearance:
Inner: 1.48 mm (0.0583 in.)
Middle: 0.68 mm (0.0268 in.)
Outer: 0.88 mm (0.0346 in.)
Coat the 1st gear cone with gear oil. Check the braking
effect of the synchronizer ring. Turn the synchronizer ring
in one direction while pushing it against the 1st gear cone.
Check that the ring locks.
INSPECT SYNCHRONIZER RING SET NO.2
Using a feeler gauge, measure the clearance between
the synchronizer ring set No.1 and the 2nd gear.
Standard clearance:
Inner: 1.48 to 2.12 mm (0.0583 to 0.0835 in.)
Middle: 0.68 to 1.92 mm (0.0268 to 0.0756 in.)
Outer: 0.88 to 1.72 mm (0.0346 to 0.0677 in.)
Minimum clearance:
Inner: 1.48 mm (0.0583 in.)
Middle: 0.68 mm (0.0268 in.)
Outer: 0.88 mm (0.0346 in.)
MT0I4−01