Toyota Tundra 2005 Service - Repair - Maintenance page 2269

MT−26
SST
MANUAL TRANSMISSION (RA60)
11.
(a)
(b)
D14027
(c)
HINT:
Do not apply preload.
(d)
D14049
(e)
(f)
(g)
(h)
D14050
If the result is not as specified, tighten and adjust the output
shaft adjust nut.
NOTICE:
Do not loosen or remove the output shaft adjust nut to ad-
just preload.
If the nut is loosened or removed, or if the preload exceeds
the specified range, replace the spacer with a new one.
(i)
D14025
− MANUAL TRANSMISSION ASSEMBLY
INSTALL OUTPUT SHAFT ADJUST NUT
Using a belt and wooden block, fasten the transmission
to the work bench.
Install a new spacer and the output shaft taper roller bear-
ing No.2.
Using SST, temporarily tighten a new nut until the loose-
ness in the output shaft is eliminated.
SST 09922−10010
Turn the output shaft 15 times to settle the bearing.
Shift to fifth gear, measure the starting torque and note it
down.
Using SST, tighten the nut.
Torque:(Reference)
220 N·m (2,240 kgf·cm, 162 ft·lbf)
SST 09922−10010
Shift to fifth gear, measure the starting torque and note it
down.
Make sure that the difference between the values mea-
sured at steps (e) and (g) is within the specified range.
Preload (at starting):
0.45 to 1.35 N·m
(4.59 to 13.77 kgf·cm, 3.98 to 11.95 in.·lbf)
Using a chisel and hammer, stake the output shaft adjust
nut.